View source for Inoculating Plates and Slants

[[Image:Sreaking_needle.jpg]]

These instructions show how to inoculate a plate of malt agar with a yeast sample to grow single cell colonies. This technique allows you to "clean" a suspect sample of yeast by selecting only one or few yeast cells for further propagation.

=What's needed=

[[Image:Streaking tools.jpg|right]]

To steak yeast onto a plate you'll need:

* a flame source for sterilizing the inoculation needle. I use a propane torch, but a gas stove, alcohol lamp or even lighter works as well
* an inoculation needle. A piece of wire works as well, but inoculation needles are cheap and you should pick one up when buying the petri dishes
* a sample of yeast. This could be an empty Wyeast smack pack, Whitle Labs vial, dregs from a bottle conditioned beer, an active fermentation, yeast sediment .... In this case I had an old White Labs vial into which I filled sterile wort to get the yeast fermenting again before taking a sample.
* an petri dish with malt agar that has been prepared in advance. (See [Making Plates Slants])

<div style="clear:both;"></div>

=Preparation=

[[Image:Streaking prep.jpg|right]]

In a draft free room undo the tape on the petri dish and place it on the table. Also open the sample if necessary. Then use the flame to glow out the full length of the needle. This sterilizes the needle.

<div style="clear:both;"></div>

=Take a sample=
[[Image:Streaking streaking.jpg|right]]

Dip the hot needle into the sample. This will cool it off and pick up some yeast. Note that you should not see blobs or drops of yeast on the needle. If this is the case you picked up way to much and you won't be able to spread it enough for district single cell growth. Don't worry if you don't see anything, there will be some yeast on the needle.

<div style="clear:both;"></div>


[[Image:Streaking grown plate.jpg]]
<div style="clear:both;"></div>