Difference between revisions of "PH Meter Buying Guide"
Line 23: | Line 23: | ||
* '''price:''' I think that you can get a decent pH meter suitable for brewing applications between $50 and $100. You can pay more but the added benefit may not be worth the money and you may be better off spending this money on another neat piece of testing equipment: A dissolved oxygen meter. | * '''price:''' I think that you can get a decent pH meter suitable for brewing applications between $50 and $100. You can pay more but the added benefit may not be worth the money and you may be better off spending this money on another neat piece of testing equipment: A dissolved oxygen meter. | ||
+ | |||
+ | [[Image:Milwaukee_SM101.jpg|frame|right|The Milwaukee SM101 pH meter is a reliable pH meter well suited for brewing that cost less than $100]] | ||
After considering all these facts I personally settled on the SM101 from Milwaukee (http://www.milwaukeetesters.com/SM101.html) | After considering all these facts I personally settled on the SM101 from Milwaukee (http://www.milwaukeetesters.com/SM101.html) |
Revision as of 02:31, 24 September 2009
When looking for pH meters you’ll find that there are a lot of different models with a variety of features and prices ranging from $50 to $500 and once you justified the expense you’ll ask yourself what meter should I get as a brewer. pH meters are glorified volt meters that measure the electrical potential produced by a special pH probe. What determines their quality and precision is the quality of the probe and the quality of the amplifier and analog-digital converter. The probe wears over time and you should expect that you’ll have to replace it every 2-3 years if you take good care of it. The probe’s response to pH is linear. This means there is a linear function between the voltage it produces and the pH of the solution it is in. This linear function has an offset and a slope which are the parameters that are set when you calibrate it. When the probe ages the slope will deteriorate and get flatter. This means you’ll get less voltage difference for the same pH difference. pH meters seem to come in 3 forms: pen-style, portable hand held and bench top. Bench top meters are generally the most precise, least mobile and most expensive. When it comes to choosing a pH meter, these are the specs and features you should look for:
NOTE: many brewers think that ATC means that you can test the mash pH at any temp within the pH meter’s temperature range. While this is true you still need to know the temperature dependent pH shift in order to correct the pH temp to the standard temperature at which the optimal pH targets were published. Briggs and DeClerck cite a pH shift of -0.35 between a room temps and a mash temp sample while my own experiments showed only -0.18. There doesn’t seem to be much data about this shift out there and the majority of the pH values that are given for brewing are room temp pH measurements. Just because a meter has ATC it is not more accurate, especially if the sample's temperature to pH function is unknown.
After considering all these facts I personally settled on the SM101 from Milwaukee (http://www.milwaukeetesters.com/SM101.html) You can find if for ~$80 on the web. It has an accuracy of 0.01, manual calibration and BNC probe connector. The temp correction is manual for the few cases where I want to measure non 25C samples. I have been using it for about 4 weeks now and am very pleased with it. After the initial calibration I have noticed an only very slight drift which means that I can trust the pH reading even without constant calibration. I check the calibration whenever I use it extensively but don’t calibrate it for occasional uses since I rarely have to change the calibration anyway. |